
复数 dedendal
n. 齿根;[机] 齿根高
The measuring instrument can measure addendum circle and dedendum circle diameter of odd-tooth gears.
这种测量工具用以测量奇数齿齿轮的齿顶圆和齿根圆直径。
Gear shape is calculated and interference of planetary gear dedendum and internal gear addendum is avoided.
齿形的几何计算可避免内齿圈齿顶与行星轮齿根发生干涉。
The computing formula of theoretical cone angle of the wormwheel addendum cone and dedendum cone can be derived yet.
推导出蜗轮齿顶圆锥的理论锥角计算公式及齿根圆锥的理论锥角计算公式。
According to the relationship which the logic rack and the logic gear is meshed, the equation of the dedendum transition curve of the logic gear is obtained.
根据逻辑齿条刀具与逻辑齿轮之间相互啮合关系,求出逻辑齿轮齿根过渡曲线方程。
This article discusses the effects of friction coefficient fon the engagement efficiency of involute cylindrical gears and the bending stress of the dedendum.
本文讨论了摩擦系数对渐开线圆柱齿轮传动啮合效率和齿根弯曲应力的影响。
dedendum(齿根高)是机械工程中齿轮设计的关键术语,指齿轮齿根到分度圆的径向距离。其核心概念与应用如下:
定义与几何意义
在标准齿轮中,dedendum 表示齿槽底部(齿根圆)与分度圆之间的垂直高度。分度圆是齿轮理论啮合的基准圆,齿根高与齿顶高(addendum)共同决定齿轮齿的完整高度(全齿高)。
与齿根圆的关系
齿根圆直径($d_f$)可通过分度圆直径($d$)和齿根高($h_f$)计算:
$$ d_f = d - 2h_f $$
其中齿根高 $h_f$ 通常为 $1.25m$($m$ 为模数),确保啮合时避免干涉。
工程作用
标准规范
国际标准(如 ISO 53)规定齿根高通常为模数的 1.25 倍($h_f = 1.25m$),但具体数值可能因压力角、修形设计调整。
权威参考来源:
在机械工程领域,"dedendum"(发音:/dɪˈdɛndəm/)是齿轮设计中的专业术语,主要含义如下:
核心定义
技术解释
相关术语扩展
应用注意
建议参考《机械设计手册》或ISO 21771标准获取更详细的几何参数计算方法。
anythingevidenceyearnkeep sb downrecessiverookiegenderbespeakingCitigroupklangLidiapapayaattitude is everythingbiological engineeringChina TelecomHouse of Commonsinterventional ultrasoundNational Malloxidative phosphorylationreflective mirroraeolotropicallergodermiaaugustnessdesiderativeendosporousgaolbirdinterchannelmicrospariteinterofficecantilever crane