結晶溫度
They and the steel wire and solid-phase liquidus temperature and the size of the crystallization temperature range.
它們與鋼的固相線和液相線溫度的高低及結晶溫度區間的大小有關。
The influence of melting temperature, melting time, crystallization temperature and cooling mode on form and size of nylon 66 was stu***d.
研究了熔融溫度、熔融時間、冷卻方式及結晶溫度對尼龍66球晶形态和大小的影響。
Parameters effecting on dry fractionation of lard are crystallization temperature, cooling rate, crystal growing time, agitation rate, separating manner.
影響豬油幹法分提參數有：結晶溫度、冷卻速率、養晶時間、攪拌速率及分離方式。
The heat-enthalpy method was used to deal with the latent heat allowing for the broad crystallization temperature interval of ZA27 alloy.
在對結晶潛熱處理的過程中，充分考慮了ZA27合金寬結晶溫度範圍特點，采用熱焓法處理。
The results show that compared with the common semi-dull PET chip,the super bright PET has higher crystallization temperature,lower crystal enthalpy and crystallinity.
結果表明,和常規半消光PET切片相比,超有光聚酯切片冷結晶溫度較高,結晶熱焓較低,結晶度較小;
It was further indicated that the apparent volume of CTCBE was decided by the crystallization temperature.
進一步表明CTCBE在自然緩冷固化的表觀體積根本上由其結晶溫度決定。
Based on crystallization mechanism, effective pour depressant should meet the requirements of carbon chain matching and crystallization temperature matching.
根據共晶機理，好的降凝劑應滿足碳數相匹配、結晶溫度相匹配要求。
The DSC results showed both the melting temperature and crystallization temperature of the grafting products were decreased.
DSC研究表明輻照接枝産物的熔融溫度和結晶溫度均降低。
With the steel line and the solid phase of the high and low liquidus temperature and crystallization temperature of the size of interval.
它們與鋼的固相線和液相線溫度的高低及結晶溫度區間的大小有關。
The results showed that solid grafted EMA could play a role of heterogeneous nucleating agent in PP, raising the crystallization temperature and crystallinity of PP.
結果表明：固相接枝EMA對PP的結晶起到異相成核的作用，提高了PP的結晶溫度和結晶度；
Crystallization temperature of the as-quenched alloys were measured by DSC.
用DSC法測定了制備态合金的晶化溫度。
The blending composition, temperature and time have a dramatic effect on the cold crystallization temperature (Tc) increases and the melting Tmperature (T m).
冷結晶溫度和熔融溫度與共混比例、共混時間、溫度等因素密切有關。
As accelerator for PET, PBT could decrease the cooling crystallization temperature and increase the melt crystallization temperature of recycled PET.
PBT作為PET結晶促進劑，降低回收PET的冷結晶溫度，提高熱結晶溫度。
The crystallization temperature and ***lectric properties of PLZT thin films with PLT seeding layers were investigated.
研究了有晶種層的PLZT薄膜的結晶溫度及介電性能。
With prolonging SSP time, the crystallization temperature of copolymers decreased and their dimension of crystals was smaller compared with that of pure PET.
但隨着固相聚合時間的延長，共聚酯的結晶溫度下降，形成的晶粒變小；
Crystallization temperature rised with decreasing viscosity.
結晶溫度隨着粘度的降低而升高。
The method overcomes the shortcoming of grain growing above the initial crystallization temperature in annealing method, successfully preparing nano-crystalline material of very small grain .
該方法避免了傳統的退火法在晶化溫度以上晶粒長大這一缺點，成功制備出晶粒極細小的納米材料。
Solidus and liquidus temperatures of the rocks and relationship between crystallinity and crystallization temperature have been determined.
确定了岩石固相線與液相線的溫度，岩石結晶程度與溫度的關系。
The study indicates that synthetic conditions such as crystallization temperature and time , the type and composition of organic templates, could effect on SAPO-11 molecular sieves synthesis greatly.
研究表明，合成條件，如晶化溫度和時間、有機模闆劑的類型和組成等，都對SAPO-11分子篩的合成有很大影響。
The effect of Fe-based amorphous alloys average electron consistence on crystallization temperature was investigated.
研究了鐵基非晶合金平均電子濃度對晶化溫度的影響。
The best peak firing temperature was existed, which was between the softening temperature and the peak crystallization temperature, and near the incipient crystallization temperature of the glass.
電阻漿料存在最佳峰值燒成溫度。 理論分析表明，最佳峰值燒成溫度應在軟化點與峰值析晶溫度之間，靠近起始析晶溫度。
The regular variation of crystallization temperature, magnetic ordering temperature and average hyperfine magnetic field of the amorphous alloys with Nb content were observed.
觀察到非晶合金的晶化溫度，磁有序溫度和平均磁超精細場有規律性的變化。
It is shown that the crystallization temperature and crystal size distribution increase with reduce of the feed ratio.
結果表明隨着物料配比的減小，結晶溫度點和結晶晶體的粒度呈現明顯的下降趨勢；
The results show that supercritical CO2 depresses the crystallization temperature of BAPC.
結果表明，超臨界CO2顯著降低BAPC的結晶溫度；
The harm of crystallization temperature returning in palm oil dry fractionation was introduced and the reasons were analyzed.
簡要說明了棕榈油幹式分提工藝結晶回溫的害處，并詳細分析了回溫的原因。
The thermal analysis was used to determine the crystallization temperature, the glass transformation temperature and low temperature relaxation temperature of the amorphous samples.
通過對非晶态樣品的熱分析，确定了它的晶化溫度、玻璃轉變溫度和低溫弛豫溫度。
|solidification point/crystallization point;結晶溫度
結晶溫度（Crystallization Temperature）是指物質從液态或熔融态轉變為固态晶體時的特定溫度範圍。該參數反映了物質内部原子、分子或離子有序排列形成晶格結構的熱力學條件，是材料科學、化學和地質學等領域的關鍵指标。
材料科學領域
在金屬加工中，結晶溫度決定合金冷卻過程中晶核形成與晶體生長的速率，直接影響材料的機械性能和微觀結構。例如，鋼的退火工藝需精确控制結晶溫度以優化晶粒尺寸（參考：ASM International《金屬手冊》）。高分子材料的結晶溫度則影響塑料制品的透明度與強度，如聚丙烯（PP）的結晶溫度區間為120℃–140℃（來源：《高分子材料科學與工程》期刊）。
化學工業應用
溶液結晶過程中，溫度控制可分離提純化合物。例如，蔗糖從糖漿中析出的結晶溫度與溶液飽和度直接相關，該原理被廣泛應用于制糖工藝（引用：美國化學會《工業化學工程基礎》）。
地質學意義
岩漿冷卻時，不同礦物的結晶溫度差異導緻火成岩的分層結構。橄榄石在約1200℃時率先結晶，而石英則在600℃–700℃形成，這一序列稱為鮑文反應系列（來源：美國地質調查局USGS火山學研究報告）。
結晶溫度（crystallization temperature）是指物質在特定條件下從液态或非晶态轉變為晶态的溫度。以下是詳細解釋：
結晶溫度是材料在冷卻或加熱過程中開始形成晶體結構的臨界溫度。例如，熔融金屬冷卻時，達到該溫度後會逐漸形成晶體。對于高分子材料，這一溫度可能表現為冷結晶溫度（cold crystallization temperature），即非晶态材料在加熱時重新結晶的溫度。
如需更完整的定義或案例，、、等來源。
【别人正在浏覽】